[Elecraft] help with DX4WIN

[Dave Perry]

Wayne,

As I said, I had this problem a few months ago.  Here is the solution from Rich, VE3KI:

What is your setting for CONFIG:VFO OFS (see CONFIG:CW WGHT in the
manual)? If you have CONFIG:VFO OFS turned on, the mode change between SSB
and CW will cause the dial frequency to jump by the CW sidetone pitch.

As I recall, I just turned OFS off in the K3 and everything was back to normal.

73,

Dave, N4QS


>I got no help from the DX4WIN reflector on this.  Maybe (hopefully) someone here can help?
> 
> I use DX4WIN 8.08 and a K3.  I have been experiencing an oddity that I have 
> not been able to resolve:
> 
> With K3 tuned to 3500.0, if I double click on a spot at 3503.5 the K3 goes 
> to 3503.5.  No problem.
> 
> With the K3 in the CW portion of the band (e.g. 3503.5) if I double click on 
> a spot at 3800.0 the K3 goes to 3800.65.
> 
> With the radio in the SSB portion of the band (e.g. 3800.0) if I double 
> click on a spot at 3503.5 the K3 goes to 3502.85.
> 
> I am getting a 650 Hz offset whenever the K3 changes modes.  This happens in 
> DX4WIN, but not in N1MM.
> 
> Neither RIT nor XIT are on.  Anyone have an idea where this is coming from?
> 
> Thanks,
> Wayne, N1WR,  K3 s/n 1945
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html