[Elecraft] Data modes issue

[Joe Subich, W4TV]

Are you sure you're hearing the audio from the K3 monitor and
not from other speakers attached to the computer?  What sound
card software are you using?  Are you sure it is configured to
use the soundcard attached to the radio and not the computer
"default" sound card if you have more than one (e.g., an interface
with built-in sound card)?

73,

    ... Joe, W4TV

On 1/8/2011 2:04 PM, Jim Littlefield wrote:
> Yes, I definitely have the MIC SEL set to LINE IN and the LINE IN gain
> at 30.
>
>
> On 1/8/2011 1:57 PM, John Ragle wrote:
>> Check in particular...
>>
>> MIC SEL = LINE IN
>>
>> also
>>
>> LIN IN set to ~10-30 depending on band...
>>
>> My mic gain runs about "LINE 30" and the SignaLink (IF USING) has TX @
>> 9 O'Clock and RX @ 11 or 12 O'Clock. (Again, IF USING SignaLink, both
>> jumpers that deal with audio olume are set to the "high" setting...see
>> instructions.)
>>
>> John Ragle -- W1ZI
>>
>> =====
>>
>> On 1/8/2011 1:47 PM, Jim Littlefield wrote:
>>> Just got my new K3 and everything is great about it except, sound card
>>> data modes (PSK31, etc.) are not working. I put the radio in Data A
>>> mode. When I transmit, the rig is keyed, I can hear audio via the
>>> monitor function, but nothing is transmitted. I have tried cranking the
>>> Mic gain (actually the line in gain) way up, but that doesn't help. I
>>> have also confirmed the transmitter is not in test mode.
>>>
>>> Any suggestions?
>>>
>>
>>
>
>