[Elecraft] P3 Utility not connecting

[Tommy Alderman]

Bob,

I'm sure you have done this already, but just in case you haven't, your K3
connects to your P3 with your serial cable and the baud rate on the K3  is
fixed between the K3 and P3 at 34800b. Then you connect your PC serial cable
to your P3 and with the P3 you can set the baud rate to what is needed for
your PC. Once you have this set up per the manual instructions, the K3/P3
system will work correct.

Tom - W4BQF


-----Original Message-----
From: elecraft-bounces at mailman.qth.net
[mailto:elecraft-bounces at mailman.qth.net] On Behalf Of Robert Redmon
Sent: Thursday, January 06, 2011 9:52 AM
To: Elecraft at mailman.qth.net
Subject: [Elecraft] P3 Utility not connecting

I am using a Microham Digikeyer to provide the USB to RS232 conversion 
and connection to the K3. I have no trouble connecting to the K3 with 
either the K3 Utility or K3 EZ or the K3 Memory Editor, but the P3 
Utility will not connect. Anyone solve this issue already?

73, Bob K5SM
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft at mailman.qth.net

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html