[Elecraft] RS 232 Connections

[Alan Bloom]

You don't need to do anything to send K3 commands with the P3 still
connected.  The P3 relays the K3 commands straight on through.  K3
Utility "thinks" it is connected directly to the K3.

You may be thinking of older versions of P3 firmware where you had to
turn off the P3 when downloading K3 firmware.  But that was fixed way
back in version 00.37 (September 2010).

Alan N1AL


On Wed, 2011-04-13 at 11:48 -0400, w5ov at w5ov.com wrote:
> Upgrade the firmware in your P3 which will allow you to access either
> without changing connections.
> 
> > Have a K3 & KUSB with the P3.  It appears that if I want to connect to
> > my PC and run the K3 utility I must disconnect the P3 during this
> > process. Curious if there are other ways to enable both.
> >
> > TIA  Dick
> >
> > ______________________________________________________________
> > Elecraft mailing list
> > Home: http://mailman.qth.net/mailman/listinfo/elecraft
> > Help: http://mailman.qth.net/mmfaq.htm
> > Post: mailto:Elecraft at mailman.qth.net
> >
> > This list hosted by: http://www.qsl.net
> > Please help support this email list: http://www.qsl.net/donate.html
> >
> 
> 
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
>