[Elecraft] KX1 Red Display Filter

[Chuck Stover]

I used two thin strips of duct tape.  The tape supplied with my kit did not hold either.

Chuck K4QS

--- On Thu, 4/7/11, Chuck Guenther <charles9415 at att.net> wrote:

> From: Chuck Guenther <charles9415 at att.net>
> Subject: [Elecraft]  KX1 Red Display Filter
> To: elecraft at mailman.qth.net
> Date: Thursday, April 7, 2011, 7:49 AM
> Instructions for installing the LED
> filter are given on page 52
> of the latest KX1 manual (Rev. E, dated May 21, 2010).
> 
> The transparent tape just didn't hold in my case, with the
> result
> that the filter is floating around inside the case
> somewhere, leaving
> the LED display chip exposed.
> 
> Has anyone discovered a better way to attach this
> filter?  I'm thinking
> of using a very small quantity of RTV sealant, judiciously
> applied
> around the edges of the filter with a toothpick.  Any
> thoughts?
> 
> Thanks & 73,
> 
> Chuck Guenther  NI0C
> KX1 s/n 2512
> 
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
>