[Elecraft] KX1 Red Display Filter

[Chuck Guenther]

Instructions for installing the LED filter are given on page 52
of the latest KX1 manual (Rev. E, dated May 21, 2010).

The transparent tape just didn't hold in my case, with the result
that the filter is floating around inside the case somewhere, leaving
the LED display chip exposed.

Has anyone discovered a better way to attach this filter?  I'm thinking
of using a very small quantity of RTV sealant, judiciously applied
around the edges of the filter with a toothpick.  Any thoughts?

Thanks & 73,

Chuck Guenther  NI0C
KX1 s/n 2512