[Elecraft] [K3] Date mode question

[David F. Reed]

Thanks Don, that did the trick!

--Dave, W5SV / NNN0SLA

On 4/4/11 1:17 PM, Don Wilhelm wrote:
>  Dave,
>
> Yes there is an easy way, just turn the SHIFT knob to set the center 
> frequency (while adjusting, it is displayed in the VFO B area) - the 
> default is 1500 Hz.  The since you want to use a 1 kHz width, adjust 
> the WIDTH knob until you see 1.00 in the VFO B display area.  If the 
> SHIFT and WIDTH LEDs are not illuminated, tap one of the knobs to 
> switch from the LO - CUT - HI selection.
>
> If you use these adjustments frequently, they can be saved in one of 
> the presets.
>
> 73,
> Don W3FPR
>
> On 4/4/2011 1:11 PM, David F. Reed wrote:
>> When I am using MT63 in MARS service (1 KHz wide), we use a center
>> frequency of 1KHz, so a pass band from 500 Hz to 1500 Hz; when I set
>> date mode, and pick either the 2.7 KHz or 2.1 KHz filter, the data mode
>> seems to cut off at a lower frequency of 1 KHz or so; is there an easy
>> way to shift the pass band down where I want it?
>>
>> Thanks and 73 de Dave, W5SV / NNN0SLA