[Elecraft] [K3] Date mode question

[Don Wilhelm]

  Dave,

Yes there is an easy way, just turn the SHIFT knob to set the center 
frequency (while adjusting, it is displayed in the VFO B area) - the 
default is 1500 Hz.  The since you want to use a 1 kHz width, adjust the 
WIDTH knob until you see 1.00 in the VFO B display area.  If the SHIFT 
and WIDTH LEDs are not illuminated, tap one of the knobs to switch from 
the LO - CUT - HI selection.

If you use these adjustments frequently, they can be saved in one of the 
presets.

73,
Don W3FPR

On 4/4/2011 1:11 PM, David F. Reed wrote:
> When I am using MT63 in MARS service (1 KHz wide), we use a center
> frequency of 1KHz, so a pass band from 500 Hz to 1500 Hz; when I set
> date mode, and pick either the 2.7 KHz or 2.1 KHz filter, the data mode
> seems to cut off at a lower frequency of 1 KHz or so; is there an easy
> way to shift the pass band down where I want it?
>
> Thanks and 73 de Dave, W5SV / NNN0SLA
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
>