[Elecraft] ELECRAFT TO TOKYO HY-POWER 2.5

[PHIL]

OK - Here is my problem, I should have worded it different.  I bought an "open box" Linear and it came without any cables.  So I guess I need to know what pins go to what pins.....I can get the connectors and build my own cable if I know what hooks where...I replaced the board in my K3 so I didn't have to do the pull-up resistor thing when I first hooked up the 1.5 unit
PHIL.  www.n2bee.net
"Sometimes I think I understand everything, then I regain consciousness"
  ----- Original Message ----- 
  From: Phil & Debbie Salas 
  To: elecraft at mailman.qth.net 
  Sent: Friday, May 28, 2010 11:55 AM
  Subject: Re: [Elecraft] ELECRAFT TO TOKYO HY-POWER 2.5


  The THP2.5 uses a regular 15-pin D-connector, whereas the K3 uses the 15-pin 
  HD D-connector.  Nothing special needs to be done, other than finding the 
  pin outs from the manuals.  The THP 2.5 even has pull-up resistors so early 
  K3 radios will drive the band data input just fine (NOT the case with the 
  THP 1.5, where you need the K3 pull-up mod).  If you plan on using ALC, you 
  do need the K3 negative-going ALC mod if you have an early K3.

  Phil - AD5X 

  ______________________________________________________________
  Elecraft mailing list
  Home: http://mailman.qth.net/mailman/listinfo/elecraft
  Help: http://mailman.qth.net/mmfaq.htm
  Post: mailto:Elecraft at mailman.qth.net

  This list hosted by: http://www.qsl.net
  Please help support this email list: http://www.qsl.net/donate.html