[Elecraft] K3 - SR2O

[Chris G3SJJ]

That's it!! I had forgotten about that menu setting. Works properly now. 
I can detect some low level crosstalk but I suspect less than the 
FT1kMP. Will check with some big sigs in WPX.

Thanks for all the responses.

Chris G3SJJ


Guy Olinger K2AV wrote:
> Make sure you have that you don't have CONFIG: L--MIX--R set to
> something other than "A   b".  Possibilities are A   b,  Ab   b, A
> Ab, Ab  Ab.  Also make sure that you have CONFIG: SUB AF set to "nor".
>
> Also it is possible to set L-MIX-R via programming over the serial
> line from a program, so it could have been left in this state from
> running a logger, etc.
>
> If those are correct, make sure you don't have a wiring error.  The
> headphone channels with the above settings are completely separate on
> my K3.
>
> 73, Guy.
>
> On Wed, May 26, 2010 at 4:14 PM, Chris G3SJJ <g3sjj at btinternet.com> wrote:
>   
>> I am trying to set up my K3 for FD here in Eu in 10 days time. I have
>> successfully used SR2O in the past with FT1kMPs but so far not with the
>> K3. I have a splitter box which takes both Rx audio channels from the
>> headphone socket and splits to one headset for main rx and another with
>> sub rx. Neither operator should hear the other rx. This works perfectly
>> with the FT1kMP but so far I can't get it to work with the K3. Any
>> suggestions?
>>
>> Chris G3SJJ