[Elecraft] K3 - SR2O

[Guy Olinger K2AV]

Make sure you have that you don't have CONFIG: L--MIX--R set to
something other than "A   b".  Possibilities are A   b,  Ab   b, A
Ab, Ab  Ab.  Also make sure that you have CONFIG: SUB AF set to "nor".

Also it is possible to set L-MIX-R via programming over the serial
line from a program, so it could have been left in this state from
running a logger, etc.

If those are correct, make sure you don't have a wiring error.  The
headphone channels with the above settings are completely separate on
my K3.

73, Guy.

On Wed, May 26, 2010 at 4:14 PM, Chris G3SJJ <g3sjj at btinternet.com> wrote:
> I am trying to set up my K3 for FD here in Eu in 10 days time. I have
> successfully used SR2O in the past with FT1kMPs but so far not with the
> K3. I have a splitter box which takes both Rx audio channels from the
> headphone socket and splits to one headset for main rx and another with
> sub rx. Neither operator should hear the other rx. This works perfectly
> with the FT1kMP but so far I can't get it to work with the K3. Any
> suggestions?
>
> Chris G3SJJ
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
>