[Elecraft] [K2] control board question

[Alan D. Wilcox]

Hi John,
You should be fine. Take your time and enjoy the build.

Finish the one K2 before you start the other. It'll go a whole lot 
smoother when you know what to expect.

Also, I'd recommend you consider getting pre-wound toroids from Mike 
Morohovich ( 412) 481-2349 toroidguy at earthlink.net. Toroids aren't much 
fun, and if the enamel isn't properly removed, any poor connections can 
lead to all sorts of grief.

Cheers, Alan

Alan D. Wilcox, W3DVX (K2-5373, K3-40)
570-321-1516
http://WilcoxEngineering.com
Williamsport, PA 17701 


John Fritze wrote:
> I started build one of the 2 K2s I ordered at Dayton (one for me and
> the second for Linda K2QYL).  After about 5 hours I have the control
> board done.  I did the resistence measurments as specified and all are
> OK, except for U6 pins 29 &30, the DIT and DAH pins.  The manual
> specifys between 70-90K ohms, I have 95K on both.  I'm guessing that
> is OK.  Or do I need to look for something fairly minor?
>
> John
> K2QY
> ______________________________________________________________
>