[Elecraft] Problem connecting LP_Bridge through the P3 to the K3

[Joe Subich, W4TV]

 > Nevertheless, it's not transparent.

Depends on one's definition of "transparent."  It appears to work with
every application I've thrown at it except for initializing LP-Bridge.
To me that implies an issue with LP-Bridge - perhaps an excessive
sensitivity to timing - not an issue with the P3/K3.

73,

    ... Joe, W4TV


On 8/8/2010 1:21 PM, Ted Roycraft wrote:
> Nevertheless, it's not transparent. Maybe we should allow it to be
> translucent? :-)
>
> 73, Ted, W2ZK
>
> On 8/8/2010 12:22 PM, Joe Subich, W4TV wrote:
>>
>>>> ... Maybe it is a nit on my
>>>> part but the RS-232 port on the P3 is supposed to be transparent to
>>>> apps
>>>> connecting to the K3 via RS-232 and it isn't - not strictly speaking
>>>> anyway since LP-Bridge hangs while connecting to the K3 if the P3 is
>>>> on. I figure now is the time to get Elecraft to address these kinds of
>>>> things.
>> I would not be so quick to blame the P3. P3 works just fine with
>> microHAM Router and other port sharing software. It may be that
>> LP-Bridge is too critical of the timing or expects the K3 to respond
>> to a particular AI or K3 mode that is incompatible with the P3.
>>
>> 73,
>>
>> ... Joe, W4TV
>>
>> ______________________________________________________________
>> Elecraft mailing list
>> Home: http://mailman.qth.net/mailman/listinfo/elecraft
>> Help: http://mailman.qth.net/mmfaq.htm
>> Post: mailto:Elecraft at mailman.qth.net
>>
>> This list hosted by: http://www.qsl.net
>> Please help support this email list: http://www.qsl.net/donate.html
>>
>>
>