[Elecraft] k3 filter setup /question

[Dick Dievendorff]

Is the filter enabled for all the modes you wish it to be used?

Dick, K6KR

Sent from my iPhone

On Aug 3, 2010, at 6:17 AM, Ted Roycraft <w2zk at comcast.net> wrote:

> John,
> 
> Are your filters installed in descending bandwidth with the widest 
> towards FL1 and the narrowest toward FL5.  The manual says this is a 
> requirement.
> 
> 73, Ted, W2ZK
> 
> On 8/3/2010 8:28 AM, john wrote:
>> On 8/3/2010 5:51 AM, Bill W4ZV wrote:
>> 
>>> john-61 wrote:
>>> 
>>> 
>>>> I have a k3 with the standard 2.7 filter and a 400hz cw filter
>>>> installed.  The 2.7 is in slot FL3 and 400hz is in slot FL4.  My
>>>> question is when you are adjusting the width of the filter should the
>>>> filter 3 number change when FL4 filter engages?  When I adjust my width
>>>> down from 2.80 down to0.05 it always shows FL3 on the display.
>>>> 
>>>> 
>>>> 
>>> Yes it sounds as you have not enabled the filter in FL4.  The easiest way to
>>> check is to use the K3 Utility's Filter Configuration screen.
>>> 
>>> 73,  Bill
>>> 
>>> 
>> Thanks Bill but, but I have checked that already and even made sure in
>> the config menu that FL4 is ON.  FL4 shows to be on in both locations.
>> Any other suggestions?
>> 
>> thanks agian
>> John
>> ______________________________________________________________
>> Elecraft mailing list
>> Home: http://mailman.qth.net/mailman/listinfo/elecraft
>> Help: http://mailman.qth.net/mmfaq.htm
>> Post: mailto:Elecraft at mailman.qth.net
>> 
>> This list hosted by: http://www.qsl.net
>> Please help support this email list: http://www.qsl.net/donate.html
>> 
>> 
>> 
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html