[Elecraft] k3 filter setup /question

[Ted Roycraft]

John,

Are your filters installed in descending bandwidth with the widest 
towards FL1 and the narrowest toward FL5.  The manual says this is a 
requirement.

73, Ted, W2ZK

On 8/3/2010 8:28 AM, john wrote:
> On 8/3/2010 5:51 AM, Bill W4ZV wrote:
>    
>> john-61 wrote:
>>
>>      
>>> I have a k3 with the standard 2.7 filter and a 400hz cw filter
>>> installed.  The 2.7 is in slot FL3 and 400hz is in slot FL4.  My
>>> question is when you are adjusting the width of the filter should the
>>> filter 3 number change when FL4 filter engages?  When I adjust my width
>>> down from 2.80 down to0.05 it always shows FL3 on the display.
>>>
>>>
>>>        
>> Yes it sounds as you have not enabled the filter in FL4.  The easiest way to
>> check is to use the K3 Utility's Filter Configuration screen.
>>
>> 73,  Bill
>>
>>      
> Thanks Bill but, but I have checked that already and even made sure in
> the config menu that FL4 is ON.  FL4 shows to be on in both locations.
> Any other suggestions?
>
> thanks agian
> John
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
>
>
>