[Elecraft] k3 filter setup /question

[john]

On 8/3/2010 5:51 AM, Bill W4ZV wrote:
>
> john-61 wrote:
>    
>> I have a k3 with the standard 2.7 filter and a 400hz cw filter
>> installed.  The 2.7 is in slot FL3 and 400hz is in slot FL4.  My
>> question is when you are adjusting the width of the filter should the
>> filter 3 number change when FL4 filter engages?  When I adjust my width
>> down from 2.80 down to0.05 it always shows FL3 on the display.
>>
>>      
> Yes it sounds as you have not enabled the filter in FL4.  The easiest way to
> check is to use the K3 Utility's Filter Configuration screen.
>
> 73,  Bill
>    
Thanks Bill but, but I have checked that already and even made sure in 
the config menu that FL4 is ON.  FL4 shows to be on in both locations.  
Any other suggestions?

thanks agian
John