[Elecraft] k3 filter setup /question

[Ian White GM3SEK]

john wrote:
>On 8/3/2010 5:51 AM, Bill W4ZV wrote:
>>
>> john-61 wrote:
>>
>>> I have a k3 with the standard 2.7 filter and a 400hz cw filter
>>> installed.  The 2.7 is in slot FL3 and 400hz is in slot FL4.  My
>>> question is when you are adjusting the width of the filter should the
>>> filter 3 number change when FL4 filter engages?  When I adjust my width
>>> down from 2.80 down to0.05 it always shows FL3 on the display.
>>>
>>>
>> Yes it sounds as you have not enabled the filter in FL4.  The easiest way to
>> check is to use the K3 Utility's Filter Configuration screen.
>>
>> 73,  Bill
>>
>Thanks Bill but, but I have checked that already and even made sure in
>the config menu that FL4 is ON.  FL4 shows to be on in both locations.
>Any other suggestions?

Speaking from personal experience... try counting FL1-2-3-4 from the 
correct end of the row.



-- 

73 from Ian GM3SEK
http://www.ifwtech.co.uk/g3sek