[Elecraft] k2 assembly question

[lstavenhagen]

I was going to also say to make sure you look at the errata. The method used
to install the diffuser is different in the errata than the one in the
manual. (i.e. the old way, you put the spacers on the diffuser leads
themselves and they stay there after installation, the new way you put them
underneath until you solder the leads. Then they're removed). 

The new way is harder to do because the spacers are free to move about, but
the finished installation looks a lot cleaner to me since you don't have
those spacers permanently stuck around the leads and on the ends of the
diffuser. And yeah the LCD goes over the diffuser. 

This part takes a LOT of care to do it right, so go slowly and carefully
following the instructions to the letter.....

73,
LS
W5QD
-- 
View this message in context: http://n2.nabble.com/k2-assembly-question-tp4841067p4842628.html
Sent from the [K2] mailing list archive at Nabble.com.