[Elecraft] No output in digital mode

[Wayne Burdick]

I know about this and am working on it.

73,
Wayne
N6KR

On Nov 7, 2009, at 4:37 PM, Dave & Jeanne Robertson wrote:

> When operating in digital A modes after holding the TUNE button,  
> which gives the proper power out indication, the following happens  
> when going into PSK transmit:
> 1, There is no power out of the K3
> 2, The ALC readout is showing the usual 3 bars and can be adjusted
> 3, There is no monitoring tone ( I have the monitor set at 6 to  
> monitor my output signal on psk).
>
> Changing modes to USB and back to Data A mode temporarily fixes the  
> problem until you hold the TUNE button again while in Data A mode.
>
> The firmware revisions that have this problems are;
> 3.44, 3.45 (a special firmware sent to me by Elecraft), and 3.52.
>
> Revisions 3.42 and below work fine. Others have reported this but I  
> just wanted to give my $0.02 worth.
>
> 73
> Dave KD1NA
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html