[Elecraft] No output in digital mode

[John E. Reiser]

> 2, The ALC readout is showing the usual 3 bars and can be adjusted

Shouldn't you be showing 4-5 bars on the ALC meter?  Maybe your audio is 
insufficient.

John


----- Original Message ----- 
From: "Dave & Jeanne Robertson" <darjar at comcast.net>
To: "Elecraft Support" <support at elecraft.com>; "Elecraft" 
<elecraft at mailman.qth.net>
Sent: Saturday, November 07, 2009 7:37 PM
Subject: [Elecraft] No output in digital mode


> When operating in digital A modes after holding the TUNE button, which 
> gives the proper power out indication, the following happens when going 
> into PSK transmit:
> 1, There is no power out of the K3
> 2, The ALC readout is showing the usual 3 bars and can be adjusted
> 3, There is no monitoring tone ( I have the monitor set at 6 to monitor my 
> output signal on psk).
>
> Changing modes to USB and back to Data A mode temporarily fixes the 
> problem until you hold the TUNE button again while in Data A mode.
>
> The firmware revisions that have this problems are;
> 3.44, 3.45 (a special firmware sent to me by Elecraft), and 3.52.
>
> Revisions 3.42 and below work fine. Others have reported this but I just 
> wanted to give my $0.02 worth.
>
> 73
> Dave KD1NA
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
>