[Elecraft] No output in digital mode

[Dave & Jeanne Robertson]

When operating in digital A modes after holding the TUNE button, which gives the proper power out indication, the following happens when going into PSK transmit:
1, There is no power out of the K3
2, The ALC readout is showing the usual 3 bars and can be adjusted
3, There is no monitoring tone ( I have the monitor set at 6 to monitor my output signal on psk).

Changing modes to USB and back to Data A mode temporarily fixes the problem until you hold the TUNE button again while in Data A mode.

The firmware revisions that have this problems are;
3.44, 3.45 (a special firmware sent to me by Elecraft), and 3.52.

Revisions 3.42 and below work fine. Others have reported this but I just wanted to give my $0.02 worth.

73
Dave KD1NA