[Elecraft] V3.19

[Iain MacDonnell - N6ML]

It's because clicking on the spot results in (at least) two actions:

1) Set the radio frequency to 50.125

2) Set the radio mode to SSB

Unfortunately the second step invokes the CW offset adjustment, and
leaves you <pitch>Hz off where you wanted to be.

If your software set the mode before setting the frequency, it should
work as you expect.

I had the same problem, using the DXLabs Suite.

     ~Iain / N6ML



Brian Alsop wrote:
> Using the CW offset feature to go from SSB > CW modes .  Works as 
> advertised.
> 
> However when I click on a spot when in CW mode to go to USB something is 
> odd:
> Example:
> In CW mode at 50.110
> Click on spot on 50.125
> Radio goes to USB mode at 50.124.47  -- 50.125 minus CW offset of 530 Hz.
> 
> Anybody else seeing this?
> 
> I also wonder why one have to use reverse CW to get to an exact CW freq 
> from USB frequency mode change.   Yes, this was stated in release.  
> However, why should it matter?  I personally always use normal CW.
> 73 de Brian/K3KO
> 
> 
> ------------------------------------------------------------------------
> 
> 
> No virus found in this outgoing message.
> Checked by AVG - www.avg.com 
> Version: 8.5.375 / Virus Database: 270.12.94/2208 - Release Date: 06/29/09 05:54:00
> 
> 
> ------------------------------------------------------------------------
> 
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
> 
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html