[Elecraft] SPL N/A with everybody on CW?

[Brett Howard]

Wow I just tried doing an EE Init and set things up from scratch for the
beginning bit and then gave things a try and I was still unable to get
cross band split to work as it should.  This nearly makes using N1MM for
SO2V nearly useless and really degrades the usefulness of the KRX3.  Man
I sure hope I can figure this out before FD!  I was excited when it was
working before!  

Before I could simply click in the log window for VFO A or on a DX Spot
and poof the TX arrow would point up.  Then simply click on a spot in
the VFO B band map and poof you're on that freq and you're TX arrow is
pointing down.  Almost felt like a SO2R setup even though it was just
SO2V.  

:(

~KC7OTG

On Fri, 2009-06-19 at 22:42 -0700, Brett Howard wrote:
> I should also state that I swear this was just working a minute ago and
> now I seem to always get SUB N/A unless both VFO's are on the same band.
> 
> On Fri, 2009-06-19 at 22:20 -0700, Brett Howard wrote:
> > Right now I've got VFO A on 14.030.00 and VFO B on 7.027.00 and I'd like
> > to transmit on the VFO B freq.  Or I'm trying to setup N1MM so that when
> > I click on the VFO B log section that it switches on split so that I can
> > TX in the right band.  But I keep getting SPL N/A.  I even then tapped
> > A->B twice and then went back to those frequencies and still got SPL
> > N/A.  Seems like I'm unable to use the split and TX on VFO B if I'm on
> > independant bands?  And yes both are set to CW.
> > 
> > Any ideas what I'm doing wrong?
> > 
>