[Elecraft] SPL N/A with everybody on CW?

[Brett Howard]

I should also state that I swear this was just working a minute ago and
now I seem to always get SUB N/A unless both VFO's are on the same band.

On Fri, 2009-06-19 at 22:20 -0700, Brett Howard wrote:
> Right now I've got VFO A on 14.030.00 and VFO B on 7.027.00 and I'd like
> to transmit on the VFO B freq.  Or I'm trying to setup N1MM so that when
> I click on the VFO B log section that it switches on split so that I can
> TX in the right band.  But I keep getting SPL N/A.  I even then tapped
> A->B twice and then went back to those frequencies and still got SPL
> N/A.  Seems like I'm unable to use the split and TX on VFO B if I'm on
> independant bands?  And yes both are set to CW.
> 
> Any ideas what I'm doing wrong?
>