[Elecraft] [K3] Low and High Power Cmd

[Matt Zilmer]

These are good candidates for macros.  T5W, T100W maybe?

73,
matt W6NIA

On Wed, 23 Dec 2009 14:25:10 -0800 (PST), you wrote:

>
>Is there such a command. I had this radio for about a year and I have to keep
>turning the knob to go from 100 watts to five watts. I don't recall in my
>book a cmd for it but was wondering if there was a firmware upgrade. I use
>my amp every day and before I use it, I always go to five watts on the
>radio, tune the antenna and then go back to high power to push the amp. I
>have to keep turning the knob and it's a pain. At the rate I'm going, this
>radio will have to sent back to Elecraft for a new knob/tumbler. This could
>get expensive. Is there something on the number panel to get this command
>up? It takes a bunch of turns to go from high to low power.