[Elecraft] [K3] Low and High Power Cmd

[Oscar Staudt]

This might work for you:  You can set the TUNE function to always work at a
separate fixed power level (I use 8 watts) that is not dependent on what
power level you have dialed in for normal ops.  Configuration Menu:  TUN PWR
    Page 60 in my user manual.

This is perfect to let my antenna coupler tune when I change bands.  No knob
turning.

On Wed, Dec 23, 2009 at 4:25 PM, -.-. --.-N3TU -.-. --.- <
connectmenow at hotmail.com> wrote:

>
> Is there such a command. I had this radio for about a year and I have to
> keep
> turning the knob to go from 100 watts to five watts. I don't recall in my
> book a cmd for it but was wondering if there was a firmware upgrade. I use
> my amp every day and before I use it, I always go to five watts on the
> radio, tune the antenna and then go back to high power to push the amp. I
> have to keep turning the knob and it's a pain. At the rate I'm going, this
> radio will have to sent back to Elecraft for a new knob/tumbler. This could
> get expensive. Is there something on the number panel to get this command
> up? It takes a bunch of turns to go from high to low power.
> --
> View this message in context:
> http://n2.nabble.com/Low-and-High-Power-Cmd-tp4210880p4210880.html
> Sent from the [K3] mailing list archive at Nabble.com.
> ______________________________________________________________
> Elecraft mailing list
> Home: http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/mmfaq.htm
> Post: mailto:Elecraft at mailman.qth.net
>
> This list hosted by: http://www.qsl.net
> Please help support this email list: http://www.qsl.net/donate.html
>