[Elecraft] [K3] Low and High Power Cmd

[-.-. --.-N3TU -.-. --.-]

Is there such a command. I had this radio for about a year and I have to keep
turning the knob to go from 100 watts to five watts. I don't recall in my
book a cmd for it but was wondering if there was a firmware upgrade. I use
my amp every day and before I use it, I always go to five watts on the
radio, tune the antenna and then go back to high power to push the amp. I
have to keep turning the knob and it's a pain. At the rate I'm going, this
radio will have to sent back to Elecraft for a new knob/tumbler. This could
get expensive. Is there something on the number panel to get this command
up? It takes a bunch of turns to go from high to low power. 
-- 
View this message in context: http://n2.nabble.com/Low-and-High-Power-Cmd-tp4210880p4210880.html
Sent from the [K3] mailing list archive at Nabble.com.