[Elecraft] [K3] KRX3 install question?

[Randy Moore]

I'm installing a KRX3 in K3 #2006 and have a small confusion.  I'm on p. 
20 of the KRX3 installation manual.  I have confirmed that R91 has a 
value of about 22 ohms (21.9 on my meter).  The 4th step on the page 
says that if that is the case, skip directly to the next page.  Being 
curious, I looked at the next step on p. 20 which talks about cutting 
some traces if they have not already been cut.  On my board, these 
traces are NOT cut.  But it looks like I have been directed to skip this 
step.  So should I cut the traces or not???

73,
Randy, KS4L