[Elecraft] [K3] KRX3 install question?

[Ron D'Eau Claire]

Thanks Randy. You should be sure the traces are cut. That step was added in
the last update and I didn't change the reference in the previous step to
say "go directly to the next step below" rather than to the next page. 

Sorry for the confusion. 

Ron AC7AC

-----Original Message-----
From: elecraft-bounces at mailman.qth.net
[mailto:elecraft-bounces at mailman.qth.net] On Behalf Of Randy Moore
Sent: Sunday, December 06, 2009 10:10 AM
To: Elecraft Discussion List
Subject: [Elecraft] [K3] KRX3 install question?

I'm installing a KRX3 in K3 #2006 and have a small confusion.  I'm on p. 
20 of the KRX3 installation manual.  I have confirmed that R91 has a 
value of about 22 ohms (21.9 on my meter).  The 4th step on the page 
says that if that is the case, skip directly to the next page.  Being 
curious, I looked at the next step on p. 20 which talks about cutting 
some traces if they have not already been cut.  On my board, these 
traces are NOT cut.  But it looks like I have been directed to skip this 
step.  So should I cut the traces or not???

73,
Randy, KS4L
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft at mailman.qth.net

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html