[Elecraft] K3 and SignaLink USB Interface

[Bud Semon N7CW]

Mike and Don,

TigerTronics just introduced a new K3 interface cable that uses the PTT,
Line in and Line Out.  It may not be on their website yet.  It's $25 instead
of $15.

73, Bud N7CW

-----Original Message-----
From: elecraft-bounces at mailman.qth.net
[mailto:elecraft-bounces at mailman.qth.net] On Behalf Of Don Wilhelm
Sent: Monday, August 24, 2009 3:47 PM
To: Michael M. Raskin
Cc: elecraft at mailman.qth.net
Subject: Re: [Elecraft] K3 and SignaLink USB Interface

Mike,

Using the ACC connector will not help a lot - there are no audio signals 
there, so the only applicable input at the ACC connector would be PTT 
IN.  It would seem just as easy to use the PTT RCA jack on the K3 
because you would be connecting to the LINE IN and LINE OUT for audio.  
The LINE OUT is pre-AF gain, you set the level using CONFIG: LIN OUT in 
the menu.

73,
Don W3FPR

Michael M. Raskin wrote:
> Anyone using this combo with the ACC (15-pin) instead of the mic jack?  DX
Engineering, and well as TigerTronics, sell all kinds of pre-made cables but
only a mic cable for the K3.  I'd rather connect to the ACC, as I do with
the IC-7800, where the audio signal is not dependent on the AF volume or mic
gain settings.
>
> Mike, W4UM
>   
>
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft at mailman.qth.net

This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html