[Elecraft] K3 and SignaLink USB Interface
Greg - AB7R
ab7r at cablespeed.com
Mon Aug 24 18:11:03 EDT 2009
No need to even use the ACC connection. You only need an audio line to Line IN,
Line Out and a line for PTT to the PTT RCA connector.
The cables are a snap to make. I cut a piece of CAT 5 cable, verify what colors go
to what pins INSIDE the SignaLink (you set the jumpers internally) and then attach
the audio plugs and the RCA for PTT and you should be all set.
Hope this helps.
-------------------------
73,
Greg - AB7R
Whidbey Island WA
NA-065
On Mon Aug 24 15:02 , "Michael M. Raskin" sent:
>Anyone using this combo with the ACC (15-pin) instead of the mic jack? DX
Engineering, and well as TigerTronics, sell all kinds of pre-made cables but only a
mic cable for the K3. I'd rather connect to the ACC, as I do with the IC-7800,
where the audio signal is not dependent on the AF volume or mic gain settings.
>
>Mike, W4UM
>______________________________________________________________
>Elecraft mailing list
>Home: http://mailman.qth.net/mailman/listinfo/elecraft
>Help: http://mailman.qth.net/mmfaq.htm
>Post: Elecraft at mailman.qth.net','','','')">Elecraft at mailman.qth.net
>
>This list hosted by: http://www.qsl.net
>Please help support this email list: http://www.qsl.net/donate.html
More information about the Elecraft
mailing list