[Elecraft] Help with download

[Chris G3SJJ]

Sorted. I had Disabled Router Queries on the mHam Router but it still 
didn't like it so I changed over a USB / Serial Interface and that 
worked. My bad. Sorry.
Chris G3SJJ

Dick Dievendorff wrote:
> When you power up the rig, if the red Tx Led is flashing and you see "MCU
> LD" in the LCD (it may not be backlit), you should still be able to load
> firmware into your K3.  Just click "Send All Firmware" and the MCU should
> start to load.  
>
> The MCU is in "boot load" status if the Red TX led is flashing.
>
> Restart the K3 Utility so that it finds the K3 again and again determines
> its baud rate (which will now be 38,400).
>
> Dick, K6KR
>
>
> -----Original Message-----
> From: elecraft-bounces at mailman.qth.net
> [mailto:elecraft-bounces at mailman.qth.net] On Behalf Of Chris G3SJJ
> Sent: Thursday, September 11, 2008 1:59 PM
> To: elecraft at mailman.qth.net
> Subject: [Elecraft] Help with download
>
> Pressed the wrong button or something! Tx LED flashing but download has 
> hung. I have switched off the PSU, switched on again and held the Power 
> button down for 30 seconds which I think I had to do once before, but no 
> success. Help please!
>
> Chris G3SJJ
> _______________________________________________
> Elecraft mailing list
> Post to: Elecraft at mailman.qth.net
> You must be a subscriber to post to the list.
> Subscriber Info (Addr. Change, sub, unsub etc.):
>  http://mailman.qth.net/mailman/listinfo/elecraft    
>
> Help: http://mailman.qth.net/subscribers.htm
> Elecraft web page: http://www.elecraft.com
>
>
>