[Elecraft] Help with download

[Joe Subich, W4TV]

> Sorted. I had Disabled Router Queries on the mHam Router but it still 
> didn't like it so I changed over a USB / Serial Interface and that 
> worked.

You must also set Radio type = None and have only one port active. 

73, 

   ... Joe, W4TV 
 



> -----Original Message-----
> From: elecraft-bounces at mailman.qth.net 
> [mailto:elecraft-bounces at mailman.qth.net] On Behalf Of Chris G3SJJ
> Sent: Thursday, September 11, 2008 6:21 PM
> To: Dick Dievendorff
> Cc: elecraft at mailman.qth.net
> Subject: Re: [Elecraft] Help with download
> 
> 
> Sorted. I had Disabled Router Queries on the mHam Router but it still 
> didn't like it so I changed over a USB / Serial Interface and that 
> worked. My bad. Sorry.
> Chris G3SJJ
> 
> Dick Dievendorff wrote:
> > When you power up the rig, if the red Tx Led is flashing 
> and you see 
> > "MCU LD" in the LCD (it may not be backlit), you should 
> still be able 
> > to load firmware into your K3.  Just click "Send All 
> Firmware" and the 
> > MCU should start to load.
> >
> > The MCU is in "boot load" status if the Red TX led is flashing.
> >
> > Restart the K3 Utility so that it finds the K3 again and again 
> > determines its baud rate (which will now be 38,400).
> >
> > Dick, K6KR
> >
> >
> > -----Original Message-----
> > From: elecraft-bounces at mailman.qth.net 
> > [mailto:elecraft-bounces at mailman.qth.net] On Behalf Of Chris G3SJJ
> > Sent: Thursday, September 11, 2008 1:59 PM
> > To: elecraft at mailman.qth.net
> > Subject: [Elecraft] Help with download
> >
> > Pressed the wrong button or something! Tx LED flashing but download 
> > has
> > hung. I have switched off the PSU, switched on again and 
> held the Power 
> > button down for 30 seconds which I think I had to do once 
> before, but no 
> > success. Help please!
> >
> > Chris G3SJJ