[Elecraft] Help with download

[Dick Dievendorff]

When you power up the rig, if the red Tx Led is flashing and you see "MCU
LD" in the LCD (it may not be backlit), you should still be able to load
firmware into your K3.  Just click "Send All Firmware" and the MCU should
start to load.  

The MCU is in "boot load" status if the Red TX led is flashing.

Restart the K3 Utility so that it finds the K3 again and again determines
its baud rate (which will now be 38,400).

Dick, K6KR


-----Original Message-----
From: elecraft-bounces at mailman.qth.net
[mailto:elecraft-bounces at mailman.qth.net] On Behalf Of Chris G3SJJ
Sent: Thursday, September 11, 2008 1:59 PM
To: elecraft at mailman.qth.net
Subject: [Elecraft] Help with download

Pressed the wrong button or something! Tx LED flashing but download has 
hung. I have switched off the PSU, switched on again and held the Power 
button down for 30 seconds which I think I had to do once before, but no 
success. Help please!

Chris G3SJJ
_______________________________________________
Elecraft mailing list
Post to: Elecraft at mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft    

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com