[Elecraft] K3 TX equalizer messes up PSK

[Alexandr Kobranov]

just info - no new real "mode" is requested
only internal interpretation in K3 dependent on real MODE and 
SOME_OTHER_CONTIDION (eg. MIC port) like only internal "virtual" mode 
for deciding which EQ profile will be used

just to prevent misunderstandings :-)
hope not needed but...
L. -dst-

Alexandr Kobranov napsal(a):
> You are right, Julian.
> 
> So what about to keep SSB FP MIc/SSB RP Mic/AM FP Mic/AM RP Mic/FM FP 
> MIc/FM/RP Mic as "independent modes" keeping their own TX/RX EQ Settings?
> So yes, let´s have 10 EQ pre-sets and make table of possible "modes" to 
> keep information about EQ pre-set. There is no need to limit "mode" only 
> to CW/AM/FM/SSB - there are possible some more precious like Rear or 
> Front panel Mic used etc...why not.
> Any other idea?
> 
> 73!
> L. -dst-
> 
> 
> 
> Julian, G4ILO napsal(a):
>>
>>
>> Alexandr Kobranov wrote:
>>>
>>> What about to have settings of RX and TX EQ not by mode but as profiles?
>>>
>>> let´s have RXEQ1, RXEQ2,....,RXEQ5,...
>>>
>>> also TXEQ1,.....TXEQ5,...
>>>
>>> all stored for possible recall
>>>
>>> someteimes is good to use more profiles in one mode - other 
>>> headphones, microfone change, other data mode,...
>>>
>>>
>> That sounds to me like if I want to switch from the desk mic (front 
>> socket)
>> to the headset (rear socket) I would have to make TWO menu selections, 
>> one
>> to change the mic input, and then another to change the profile. Since I
>> don't change the EQ settings once they are set up for these mics, I would
>> prefer to have the EQ change automatically with the change of input 
>> source.
>>
>> I'm guessing that some people might like to have different EQ settings 
>> for,
>> say, DX and normal contacts, for use with the same microphone. So I 
>> can see
>> the sense in your suggestion, although for those who don't have such a
>> requirement it just adds extra complication.
>>
>> -----
>> Julian, G4ILO. K2 #392  K3 #222.
>> http://www.g4ilo.com/ G4ILO's Shack   http://www.ham-directory.com/ Ham
>> Directory    http://www.g4ilo.com/kcomm.html KComm for Elecraft K2 and K3 
> 
> _______________________________________________
> Elecraft mailing list
> Post to: Elecraft at mailman.qth.net
> You must be a subscriber to post to the list.
> Subscriber Info (Addr. Change, sub, unsub etc.):
> http://mailman.qth.net/mailman/listinfo/elecraft   
> Help: http://mailman.qth.net/subscribers.htm
> Elecraft web page: http://www.elecraft.com
>