[Elecraft] K3 TX equalizer messes up PSK

[Alexandr Kobranov]

You are right, Julian.

So what about to keep SSB FP MIc/SSB RP Mic/AM FP Mic/AM RP Mic/FM FP 
MIc/FM/RP Mic as "independent modes" keeping their own TX/RX EQ Settings?
So yes, let´s have 10 EQ pre-sets and make table of possible "modes" 
to keep information about EQ pre-set. There is no need to limit "mode" 
only to CW/AM/FM/SSB - there are possible some more precious like Rear 
or Front panel Mic used etc...why not.
Any other idea?

73!
L. -dst-



Julian, G4ILO napsal(a):
> 
> 
> Alexandr Kobranov wrote:
>>
>> What about to have settings of RX and TX EQ not by mode but as profiles?
>>
>> let´s have RXEQ1, RXEQ2,....,RXEQ5,...
>>
>> also TXEQ1,.....TXEQ5,...
>>
>> all stored for possible recall
>>
>> someteimes is good to use more profiles in one mode - other 
>> headphones, microfone change, other data mode,...
>>
>>
> That sounds to me like if I want to switch from the desk mic (front socket)
> to the headset (rear socket) I would have to make TWO menu selections, one
> to change the mic input, and then another to change the profile. Since I
> don't change the EQ settings once they are set up for these mics, I would
> prefer to have the EQ change automatically with the change of input source.
> 
> I'm guessing that some people might like to have different EQ settings for,
> say, DX and normal contacts, for use with the same microphone. So I can see
> the sense in your suggestion, although for those who don't have such a
> requirement it just adds extra complication.
> 
> -----
> Julian, G4ILO. K2 #392  K3 #222.
> http://www.g4ilo.com/ G4ILO's Shack   http://www.ham-directory.com/ Ham
> Directory    http://www.g4ilo.com/kcomm.html KComm for Elecraft K2 and K3