[Elecraft] K3 836 noTX

[Alexandr Kobranov]

Maybe stupid Question - have you Jumper installed if you are without 
PA yet?
I mean jumper close to rear panel which has to be removed during 
install of PA 100W. Normally K3/10 are coming with this installed (as 
mine) I do not know if you have k3/100

Lexa, -dst-

charles napsal(a):
> On Thursday 08 May 2008 13:49:00 epalmer at sirisonline.com wrote:
> 
>> I'll ask the obvious question and forgive me for doing so. In the CONFIG
>> menu is setting for PA at nor? This should enable the PA.
> 
> Thanks for the reply Ed.
> I have not yet installed the KPA3.
> The Installation Manual calls for a low power test prior to installing the 
> KPA3.  I have not been able complete this test so far :-(
> 
> Page 51 of the Owner's Manual requires the setting of PA NOR only if the KPA3 
> is installed.  The same paragraph also refers to a KPAIO3 transition PC board 
> but I can find no mention of this item on the Elecraft web site.
> 
> Charles - M0BIN
> _______________________________________________
> Elecraft mailing list
> Post to: Elecraft at mailman.qth.net
> You must be a subscriber to post to the list.
> Subscriber Info (Addr. Change, sub, unsub etc.):
>  http://mailman.qth.net/mailman/listinfo/elecraft    
> 
> Help: http://mailman.qth.net/subscribers.htm
> Elecraft web page: http://www.elecraft.com
>