[Elecraft] K3 836 noTX

[Greg - AB7R]

Charles,

This means that somehow you do not have a correct filter setup for TX.  Go to the 
FLTX config menu item and make sure you have it set to the FLx slot where either 
your 2.7 or 2.8  filter is installed.  Do this for ALL MODES...including the ALT 
modes....USB/LSB, CW and CW REV, Data and Data Rev.  AM and FM must use their 
respective filters for TX.  

That SHOULD clear your problem.

-------------------------
73,
Greg - AB7R
Whidbey Island WA
NA-065


On Thu May  8  3:07 , charles  sent:

>ERR TXF error message received when attempting low power calibration.
>
>No power out on CW or SSB.
>
>I have studied the trouble shooting pages in the Owner's manual but cannot 
>find the answer.
>
>Any suggestions please?
>
>Charles - M0BIN
>
>Sorry I should have stated that firmware revisions are:
>
>MCU 1.88    DSP 1.70
>
>Using Elecraft Utility version 1.1.4.1
>
>Charles - M0BIN
>_______________________________________________
>Elecraft mailing list
>Post to: Elecraft at mailman.qth.net
>You must be a subscriber to post to the list.
>Subscriber Info (Addr. Change, sub, unsub etc.):
> http://mailman.qth.net/mailman/listinfo/elecraft    
>
>Help: http://mailman.qth.net/subscribers.htm
>Elecraft web page: http://www.elecraft.com