[Elecraft] K3 836 noTX

[charles]

On Thursday 08 May 2008 13:49:00 epalmer at sirisonline.com wrote:

> I'll ask the obvious question and forgive me for doing so. In the CONFIG
> menu is setting for PA at nor? This should enable the PA.

Thanks for the reply Ed.
I have not yet installed the KPA3.
The Installation Manual calls for a low power test prior to installing the 
KPA3.  I have not been able complete this test so far :-(

Page 51 of the Owner's Manual requires the setting of PA NOR only if the KPA3 
is installed.  The same paragraph also refers to a KPAIO3 transition PC board 
but I can find no mention of this item on the Elecraft web site.

Charles - M0BIN