[Elecraft] K3: can't calibrate at 50 watts

[Stewart Baker]

I found that WMTR LP stays selected until you advance the PWR 
control beyond 12W, then it shows WMTR HP. I hope that this helps.

73
Stewart G3RXQ
On Wed, 19 Mar 2008 06:23:44 -0400, DOUGLAS ZWIEBEL wrote:
> I am posting this for Stan (shown below) who is not yet 
subscribed to the list.
> de Doug KR2Q
>
>
> Hi All,
>
> I installed KPA3, turned it ON in CONFIG, but no way to 
Calibrate 50W Wattmeter.
> Still stays in WMTR LP. Sticking pins are cut off on KPAI03 
Board.
> Out of K-3 only Low Power. KPA3 doesn't work.
>
> Any advice, please.
>
> 73!  Stan,  K6WG
> k6wg at yahoo dot com
> _______________________________________________
> Elecraft mailing list
> Post to: Elecraft at mailman.qth.net
> You must be a subscriber to post to the list.
> Subscriber Info (Addr. Change, sub, unsub etc.):
> http://mailman.qth.net/mailman/listinfo/elecraft
>
> Help: http://mailman.qth.net/subscribers.htm
> Elecraft web page: http://www.elecraft.com