[Elecraft] K3: can't calibrate at 50 watts

[DOUGLAS ZWIEBEL]

I am posting this for Stan (shown below) who is not yet subscribed to the list.
de Doug KR2Q



Hi All,

I installed KPA3, turned it ON in CONFIG, but no way to Calibrate 50W Wattmeter.
Still stays in WMTR LP. Sticking pins are cut off on KPAI03 Board.
Out of K-3 only Low Power. KPA3 doesn't work.

Any advice, please.

73!  Stan,  K6WG
k6wg at yahoo dot com