[Elecraft] K3: can't calibrate at 50 watts

[Thomas Norff]

Hi Stan,

if i did not missunderstand you, the KPA3 is not working.
If that is the fact i would first of all check for the settings.
A common issue with the config menu is to select  "io nor" instead of "nor"
to enable the kpa.
As a result you will not get beyond 12W...

73 
Thomas, DM7TN
K3/100 #78


-----Original Message-----
From: elecraft-bounces at mailman.qth.net
[mailto:elecraft-bounces at mailman.qth.net] On Behalf Of DOUGLAS ZWIEBEL
Sent: Wednesday, March 19, 2008 11:24 AM
To: Elecraft Reflector
Subject: [Elecraft] K3: can't calibrate at 50 watts

I am posting this for Stan (shown below) who is not yet subscribed to the
list.
de Doug KR2Q



Hi All,

I installed KPA3, turned it ON in CONFIG, but no way to Calibrate 50W
Wattmeter.
Still stays in WMTR LP. Sticking pins are cut off on KPAI03 Board.
Out of K-3 only Low Power. KPA3 doesn't work.

Any advice, please.

73!  Stan,  K6WG
k6wg at yahoo dot com
_______________________________________________
Elecraft mailing list
Post to: Elecraft at mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft    

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com