[Elecraft] K3: ERR PL1

[Tom Hammond]

Joe:

Refer to the Manual, and run VCO MD as directed there.

That did it for me... last night, for that matter.

73,

Tom Hammond   N0SS

At 12:16 06/12/2008, Joe Word wrote:
>After upgrading to 2.02 firmware I get the error message "ERR PL1"
>when I go to 12 meters in SSB mode. The message stays on the screen
>for a few seconds.
>
>Anybody else see this?
>
>
>Joe  N9VX
>_______________________________________________
>Elecraft mailing list
>Post to: Elecraft at mailman.qth.net
>You must be a subscriber to post to the list.
>Subscriber Info (Addr. Change, sub, unsub etc.):
>  http://mailman.qth.net/mailman/listinfo/elecraft
>
>Help: http://mailman.qth.net/subscribers.htm
>Elecraft web page: http://www.elecraft.com