[Elecraft] K3: ERR PL1

[Stephen Prior]

This is too spooky for words.  Just for fun when I saw your reply Joe I
qsy'd from 10 down to 12 and there was the error- I swear it was not there
when I had the same issue with 40 before.

Now, two minutes after typing the above paragraph, the problem on 12m has
disappeared as mysteriously as it had on 40m.  However, it does appear if I
turn the K3 off and then back on again, but not as I go from 10 to 12 or
from 15m!  Must be time for a glass of something soothing!

But as you say, the radio still seems to work.  Bit of a bug somewhere I
should think!

Stephen G4SJP


On 12/06/2008 18:52, "Joe Word" <joe.n9vx at gmail.com> wrote:

> Stephen,
> 
> I did the on/off process, but no change. 12 meters works just fine...
> I am talking there now!
> 
> Joe  N9VX
> 
> On 6/12/08, Stephen Prior <sjp at sjprior.fsnet.co.uk> wrote:
>> I had the same happen to me after going to 2.02, except for me it was on
>> 40m.  Whichever direction I approached the band from it happened just as you
>> describe.  Odd thing is, without any action on my part it went away and
>> never came back!
>> 
>> I am wondering if I had powered the off and then on again after the firmware
>> upload?
>> 
>> Stephen G4SJP
>> 
>> 
>> On 12/06/2008 18:16, "Joe Word" <joe.n9vx at gmail.com> wrote:
>> 
>>> After upgrading to 2.02 firmware I get the error message "ERR PL1"
>>> when I go to 12 meters in SSB mode. The message stays on the screen
>>> for a few seconds.
>>> 
>>> Anybody else see this?
>>> 
>>> 
>>> Joe  N9VX
>>> _______________________________________________
>>> Elecraft mailing list
>>> Post to: Elecraft at mailman.qth.net
>>> You must be a subscriber to post to the list.
>>> Subscriber Info (Addr. Change, sub, unsub etc.):
>>>  http://mailman.qth.net/mailman/listinfo/elecraft
>>> 
>>> Help: http://mailman.qth.net/subscribers.htm
>>> Elecraft web page: http://www.elecraft.com
>>> 
>> 
>> 
>> 
>> 
>