[Elecraft] K3: ERR PL1

[Ken Wagner K3IU]

OK... my next suggestion is that you communicate the problem to 
K3support at elecraft.com.
73,
Ken K3IU

Stephen Prior wrote:
> Ken
>
> I don't know about Joe, but that makes no difference for me.  The appearance
> of the error message is still there but now only when I turn the radio on
> and it is already on 12m.  Strange.  Never mind.....
>
> 73 Stephen G4SJP
>
>
> On 12/06/2008 19:09, "Ken K3IU" <kenk3iu at cox.net> wrote:
>
>   
>> Joe:
>> I would suggest that you redo the CONFIG:VCO MD procedure (pg 46 of the
>> Owner's Manual).
>> 73,
>> Ken K3IU
>>
>> Joe Word wrote:
>>     
>>> Stephen,
>>>
>>> I did the on/off process, but no change. 12 meters works just fine...
>>> I am talking there now!
>>>
>>> Joe  N9VX
>>>
>>> On 6/12/08, Stephen Prior <sjp at sjprior.fsnet.co.uk> wrote:
>>>   
>>>       
>>>> I had the same happen to me after going to 2.02, except for me it was on
>>>> 40m.  Whichever direction I approached the band from it happened just as you
>>>> describe.  Odd thing is, without any action on my part it went away and
>>>> never came back!
>>>>
>>>> I am wondering if I had powered the off and then on again after the firmware
>>>> upload?
>>>>
>>>> Stephen G4SJP
>>>>
>>>>
>>>> On 12/06/2008 18:16, "Joe Word" <joe.n9vx at gmail.com> wrote:
>>>>
>>>>     
>>>>         
>>>>> After upgrading to 2.02 firmware I get the error message "ERR PL1"
>>>>> when I go to 12 meters in SSB mode. The message stays on the screen
>>>>> for a few seconds.
>>>>>
>>>>> Anybody else see this?
>>>>>
>>>>>
>>>>> Joe  N9VX
>>>>>           
>