[Elecraft] K3: ERR PL1

[Stephen Prior]

Ken

I don't know about Joe, but that makes no difference for me.  The appearance
of the error message is still there but now only when I turn the radio on
and it is already on 12m.  Strange.  Never mind.....

73 Stephen G4SJP


On 12/06/2008 19:09, "Ken K3IU" <kenk3iu at cox.net> wrote:

> Joe:
> I would suggest that you redo the CONFIG:VCO MD procedure (pg 46 of the
> Owner's Manual).
> 73,
> Ken K3IU
> 
> Joe Word wrote:
>> Stephen,
>> 
>> I did the on/off process, but no change. 12 meters works just fine...
>> I am talking there now!
>> 
>> Joe  N9VX
>> 
>> On 6/12/08, Stephen Prior <sjp at sjprior.fsnet.co.uk> wrote:
>>   
>>> I had the same happen to me after going to 2.02, except for me it was on
>>> 40m.  Whichever direction I approached the band from it happened just as you
>>> describe.  Odd thing is, without any action on my part it went away and
>>> never came back!
>>> 
>>> I am wondering if I had powered the off and then on again after the firmware
>>> upload?
>>> 
>>> Stephen G4SJP
>>> 
>>> 
>>> On 12/06/2008 18:16, "Joe Word" <joe.n9vx at gmail.com> wrote:
>>> 
>>>     
>>>> After upgrading to 2.02 firmware I get the error message "ERR PL1"
>>>> when I go to 12 meters in SSB mode. The message stays on the screen
>>>> for a few seconds.
>>>> 
>>>> Anybody else see this?
>>>> 
>>>> 
>>>> Joe  N9VX
>>>> _______________________________________________
>>>> Elecraft mailing list
>>>> Post to: Elecraft at mailman.qth.net
>>>> You must be a subscriber to post to the list.
>>>> Subscriber Info (Addr. Change, sub, unsub etc.):
>>>>  http://mailman.qth.net/mailman/listinfo/elecraft
>>>> 
>>>> Help: http://mailman.qth.net/subscribers.htm
>>>> Elecraft web page: http://www.elecraft.com
>>>> 
>>>>       
>>> 
>>> 
>>>     
>> _______________________________________________
>> Elecraft mailing list
>> Post to: Elecraft at mailman.qth.net
>> You must be a subscriber to post to the list.
>> Subscriber Info (Addr. Change, sub, unsub etc.):
>>  http://mailman.qth.net/mailman/listinfo/elecraft
>> 
>> Help: http://mailman.qth.net/subscribers.htm
>> Elecraft web page: http://www.elecraft.com
>> 
>>   
> _______________________________________________
> Elecraft mailing list
> Post to: Elecraft at mailman.qth.net
> You must be a subscriber to post to the list.
> Subscriber Info (Addr. Change, sub, unsub etc.):
>  http://mailman.qth.net/mailman/listinfo/elecraft
> 
> Help: http://mailman.qth.net/subscribers.htm
> Elecraft web page: http://www.elecraft.com
>