[Elecraft] K3: ERR PL1

[Ken K3IU]

Joe:
I would suggest that you redo the CONFIG:VCO MD procedure (pg 46 of the 
Owner's Manual).
73,
Ken K3IU

Joe Word wrote:
> Stephen,
>
> I did the on/off process, but no change. 12 meters works just fine...
> I am talking there now!
>
> Joe  N9VX
>
> On 6/12/08, Stephen Prior <sjp at sjprior.fsnet.co.uk> wrote:
>   
>> I had the same happen to me after going to 2.02, except for me it was on
>> 40m.  Whichever direction I approached the band from it happened just as you
>> describe.  Odd thing is, without any action on my part it went away and
>> never came back!
>>
>> I am wondering if I had powered the off and then on again after the firmware
>> upload?
>>
>> Stephen G4SJP
>>
>>
>> On 12/06/2008 18:16, "Joe Word" <joe.n9vx at gmail.com> wrote:
>>
>>     
>>> After upgrading to 2.02 firmware I get the error message "ERR PL1"
>>> when I go to 12 meters in SSB mode. The message stays on the screen
>>> for a few seconds.
>>>
>>> Anybody else see this?
>>>
>>>
>>> Joe  N9VX
>>> _______________________________________________
>>> Elecraft mailing list
>>> Post to: Elecraft at mailman.qth.net
>>> You must be a subscriber to post to the list.
>>> Subscriber Info (Addr. Change, sub, unsub etc.):
>>>  http://mailman.qth.net/mailman/listinfo/elecraft
>>>
>>> Help: http://mailman.qth.net/subscribers.htm
>>> Elecraft web page: http://www.elecraft.com
>>>
>>>       
>>
>>
>>     
> _______________________________________________
> Elecraft mailing list
> Post to: Elecraft at mailman.qth.net
> You must be a subscriber to post to the list.
> Subscriber Info (Addr. Change, sub, unsub etc.):
>  http://mailman.qth.net/mailman/listinfo/elecraft    
>
> Help: http://mailman.qth.net/subscribers.htm
> Elecraft web page: http://www.elecraft.com
>
>