[Elecraft] K3: ERR PL1

[Joe Word]

Stephen,

I did the on/off process, but no change. 12 meters works just fine...
I am talking there now!

Joe  N9VX

On 6/12/08, Stephen Prior <sjp at sjprior.fsnet.co.uk> wrote:
> I had the same happen to me after going to 2.02, except for me it was on
> 40m.  Whichever direction I approached the band from it happened just as you
> describe.  Odd thing is, without any action on my part it went away and
> never came back!
>
> I am wondering if I had powered the off and then on again after the firmware
> upload?
>
> Stephen G4SJP
>
>
> On 12/06/2008 18:16, "Joe Word" <joe.n9vx at gmail.com> wrote:
>
> > After upgrading to 2.02 firmware I get the error message "ERR PL1"
> > when I go to 12 meters in SSB mode. The message stays on the screen
> > for a few seconds.
> >
> > Anybody else see this?
> >
> >
> > Joe  N9VX
> > _______________________________________________
> > Elecraft mailing list
> > Post to: Elecraft at mailman.qth.net
> > You must be a subscriber to post to the list.
> > Subscriber Info (Addr. Change, sub, unsub etc.):
> >  http://mailman.qth.net/mailman/listinfo/elecraft
> >
> > Help: http://mailman.qth.net/subscribers.htm
> > Elecraft web page: http://www.elecraft.com
> >
>
>
>
>