[Elecraft] K3: ERR PL1

[Stephen Prior]

I had the same happen to me after going to 2.02, except for me it was on
40m.  Whichever direction I approached the band from it happened just as you
describe.  Odd thing is, without any action on my part it went away and
never came back!

I am wondering if I had powered the off and then on again after the firmware
upload?

Stephen G4SJP


On 12/06/2008 18:16, "Joe Word" <joe.n9vx at gmail.com> wrote:

> After upgrading to 2.02 firmware I get the error message "ERR PL1"
> when I go to 12 meters in SSB mode. The message stays on the screen
> for a few seconds.
> 
> Anybody else see this?
> 
> 
> Joe  N9VX
> _______________________________________________
> Elecraft mailing list
> Post to: Elecraft at mailman.qth.net
> You must be a subscriber to post to the list.
> Subscriber Info (Addr. Change, sub, unsub etc.):
>  http://mailman.qth.net/mailman/listinfo/elecraft
> 
> Help: http://mailman.qth.net/subscribers.htm
> Elecraft web page: http://www.elecraft.com
>