[Elecraft] Power Calibration - Transverter

[Dick Dievendorff]

There is mention of attaching a dummy load to the KXV3 Transverter Out in
the K3 Utility's Tx Gain Calibration wizard, and the K3 Utility Help text
for this wizard page says "Some versions of the K3 Owner's Manual do not
describe the dummy load requirement for Milliwatt calibration. This will be
corrected in subsequent versions of the K3 Owner's Manual."

Dick, K6KR


-----Original Message-----
From: elecraft-bounces at mailman.qth.net
[mailto:elecraft-bounces at mailman.qth.net] On Behalf Of Jim - W6VAR
Sent: Friday, December 26, 2008 12:03 PM
To: elecraft at mailman.qth.net
Subject: [Elecraft] Power Calibration - Transverter


When doing the power calibration for the transverter, there is no mention in
the manual of attaching any form of (dummy) load. Is this not necessary due
to the low power level? Wouldn't a specific impedance be necessary to
accuratly calibrate?

I'm not using a trasverter right now, but have run the calibration and would
like to know the correct way of presenting a load if needed.

Thanks,

Jim - W6VAR
-- 
View this message in context:
http://n2.nabble.com/Power-Calibration---Transverter-tp1930595p1930595.html
Sent from the Elecraft mailing list archive at Nabble.com.

_______________________________________________
Elecraft mailing list
Post to: Elecraft at mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft    

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com